The Equisoft Support System
	EQUISOFT Suggested Guidelines for use " Remove the shoes on the affected feet. " Pick out and clean the sole frog and bars, paying particular attention to the sulci of the frogs. " Hoof test the feet, to find the most painful areas. " Place, one piece of the enclosed foam, onto the bottom of the foot and trace round the foot. " Cut the foam a little larger than the foot. " Cut three pieces of the enclosed tape, approximately 10cm (four inches) longer than the widest part of the foot. " The two part impression is to be place in the back part of the foot BEHIND the most painful areas of the foot. " Take the WHITE impression material and fill ONE HALF of one foot, BEHIND the painful areas. (This is to check the correct amount required) " Remove the white impression material from the foot. " Take an equal amount of the pink impression material and mix the two parts together until both parts are blended together. " Place the blended impression material into the back part of the foot BEHIND the painful areas. Place the three pieces of pre cut tape, width ways over the impression material and place the foot onto the floor. " The impression material has to set up, (approximately 5 -10 minutes). " Trim any impression material that may have spread over the painful areas of the foot. " Remove the backing paper and tape the foam, (GLUE SIDE TO THE FOOT), over the bottom of the foot. Use some of the remaining tape to further secure the pad to the foot by wrapping the pad and foot together. Place some of the wraps over the bulbs of the heels. Thank you for choosing one of our hoof care products to help your patient achieve soundness. Further information on our products and services can be obtained by contacting us on +44(0)1403 791000 visit our website http://www.totalfootprotection.com/ or email us, post@tfp.uk.com.